In MAX recording mode, the display always shows the maximum
readings of all readings taken since entering this mode. Whenever
the tester detects a new value which is higher than the presently
displayed reading, it replaces the presently displayed reading with
this new value.
If you need to return to real-time measurement mode, long press the
" " button until the symbol " " disappears from the display.
The tester has two magnetic field units. You can briefly press the
" " button to switch the MF unit between mG and μT.
5. Switching Units
Press and hold the " " button to enable or disable the automatic
power-off feature. When the automatic power-off feature is enabled,
the symbol " " will appear on the display.
If there is no button press for about 10 minutes, the tester will turn off
automatically.
6. Automatic Power-off
To turn off the tester, press and hold the " " button for about 2
seconds.
7. Turning off the tester
- 10 -
To Next Page
Loading...