- 31 -
capacitance reading on the primary display. The secondary display
shows the ambient temperature.
Note:
1. Before measurement, make sure that the capacitor to be tested has
been discharged thoroughly.
2. For measurements > 10uF, it may take about 30 secs for the meter to
complete measurement and stabilize reading.
Measuring Frequency and Duty Cycle
1. Connect the black test lead to the " COM " terminal, and the red test
leads to the " INPUT " terminal.
2. Set the rotary switch to the " " position.
3. Connect the test leads to the source or circuit to be tested.
4. The primary display shows the frequency reading, and the secondary
display shows the duty cycle of the square wave signal being
measured.
Note:
1. For frequency measurements, range change is automatic, and
measurement range is: 0 ~ 10MHz.
2. The voltage of input signal is required to be in the range of 2V rms to
20V rms. The higher the frequency of input signal, the higher the
required input voltage.
To Next Page
Loading...
