5
BEFORE USE
IMPORTANT: The cooking zones will not switch on if pots are not the right
size. Only use pots bearing the symbol “INDUCTION SYSTEM” (Figure
below) or enameled pots. Place the pot on the required cooking zone
before switching the hob on.
EXISTING POTS AND PANS
Use a magnet to check if the pot is suitable for the induction hob: pots and
pans are unsuitable if not magnetically detectable.
Make sure pots have a smooth bottom, otherwise they could scratch
the hob. Check dishes.
Never place hot pots or pans on the surface of the hob’s control panel.
This could result in damage.
The bottom diameter of pots or pans should be at least 10cm
.
To Next Page
Loading...
