9.When the machine is driven by an electric drill, remove the handle first,
then install the connecting screw for the drill (do not need to add a gasket),
and use the electric drill last.
Diagram of removing the electric drill screws
10.First, assemble the handle, then hold the handle with one hand and use
the electric drill with the other hand to turn the drill counterclockwise to
remove the screw.
NOTE: Never put your hand in when the machine is running (you must stop
the machine before checking, debugging, and troubleshooting the
machine). To avoid cutting your hand,do not touch the blade directly with
your hand.
To Next Page
Loading...
