1
. Transmitter low battery indicator. When this low battery indicator ( )
appears, the battery in the transmitter is not high enough and must be replaced
immediately; otherwise the transmitter will not work normally
.
2
. Receiver battery level indicator used to indicate the level of the battery in the
receiver. When this indicator becomes " ", the battery in the receiver is
not high enough and must be replaced immediately; otherwise the receiver will
not work normally.
3
. A display that has two kinds of uses as described below:
In the automatic mode, PINPOINT mode, or mains voltage detection mode,
this display area showsthe numeric value of the intensity of the signal being
detected by the receiver. The higher the intensity of the signal being detected,
the higher the numeric value being displayed.
In the manual mode or selective mode, this display area shows the present
sensitivity degree ( 1 - 8 ) of the receiver.
4
. Indicates that the receiver is in the PINPOINT mode.
5
. Arcs graph display. In the manual mode or selective mode, this display
graphically shows the present sensitivity degree of the receiver. One arc on this
arcs graph display represents one sensitivity degree.( For example, the graph
" " stands for sensitivity degree 2, the graph " " stands for
sensitivity degree 3, and so on ). The more arcs present on this display, the
higher sensitivity degree the receiver.is at, and the higher sensitivity the receiver
has.
6
. Indicates that the built-in buzzer of the receiver is disabled and that the
receiver is mute.
7
. Indicates that the receiver is in the selective mode.
8
. Indicates that the receiver is in the manual mode.
9
. Indicates that the receiver is in the automatic mode.
10
. Indicates that the light on the receiver is has been turned on.
11
. Indicates that the receiver is in the mains voltage detection mode
.
12
. Bargraph that indicate the present intensity of the signal being detected by the
receiver. The higher the bargraph, the higher the present intensity of the signal
being detected by the receiver.
13
. An alarm icon that will appears when the receiver detects a mains voltage.
14
. Transmission code display that shows the present transmission code of the
To Next Page
Loading...
