VEVOR YX1320-1 - User Manual

Questions and Answers

M
Michelle JuarezAug 10, 2025
What to do if the VEVOR YX1320-1 motor does not turn when pressing the remote?
- D
  dbridgesAug 10, 2025
  If the motor doesn't turn when you press the remote control button, here are a few things to check: * Ensure the power supply is on. * Inspect the cable connections for any breaks or looseness, and repair if needed. * Examine the switch for faults; repair or replace it if necessary. * Consider capacitor damage, replace it, if needed. * For rise button failures, verify the limit frame is reset or the travel switch is in order. * Also, make sure the emergency stop switch is reset.
A
Ashley SandovalAug 18, 2025
Why is my VEVOR Chain Hoists motor noisy and not starting normally?
- W
  Willie HarrellAug 18, 2025
  If your motor is noisy and not starting normally after pressing the remote, the issue might be: * The power supply voltage being too low, in that case you should adjust it. * Capacitor damage, which would require replacing the capacitor. * Poor contact in the remote control switch, which means you should repair or replace the switch.
J
Jeremy HopkinsAug 26, 2025
What to do if there is electrification of VEVOR Chain Hoists machine casing?
- T
  Tammy RyanAug 26, 2025
  If the machine casing is electrified, it could be due to: * A faulty or ungrounded ground. Check and repair the ground cable. * An internal conductor grounded with the housing. Check and repair the internal cables.
N
Nicole WellsSep 1, 2025
What to do if the lifting instruction is contrary to the execution result in VEVOR YX1320-1?
- D
  Denise MartinezSep 1, 2025
  If the lifting instruction is contrary to the execution result, it means that improper operation caused the wire rope to reverse wrap around the drum. Press the lift switch to make the hook drop to the bottom and the wire rope completely out of the rope barrel, and then start the normal work.