Viavi OneExpert DSL - Page 56

Chapter 3 Utilities
OneExpert DSL User's Guide
22052280, Rev. 016 May 202056
Static
IPv4 Address – Enter the instrument’s IP address (which will be used when
accessing the provider network).
IPv4 Netmask – Enter the netmask address to indicate whether the packets are
to be routed to other networks or sub-networks.
IPv4 Gateway – Enter the address for the gateway that is used to route packets
that are not on the same subnet.
IPv4 DNS Server – Enter the address of the DNS server.
Shared – Share the IP from another interface (for the multi interface mode).
y If you specified IPv6 as your network mode, specify the following settings:
IPv6 Address Mode
DHCPv6
DHCPv6 Request Type
y Address – Specify the address.
y Prefix – Specify the prefix.
Stateless
IPv6 DNS Address Mode
y DHCPv6 – No additional settings to specify.
y Manual – Enter the IPv6 DNS Server address.
Static
IPv6 Global Address – Enter the instrument’s IPv6 address to access the global
network.
IPv6 Local Address
y Manual – Enter the IPv6 Local Address.
y Automatic – The address is populated automatically.
IPv6 Subnet Prefix Length – Enter the subnet prefix length.
IPv6 Gateway – Enter the address for the gateway that is used to route packets
that are not on the same subnet.
IPv6 DNS Address Mode
y DHCPv6 – No additional settings to specify.
y Manual – Enter the IPv6 DNS Server address.
y If you specified IPv4/IPv6 Dual Stack as your network mode, specify the
following settings: