Need help?Do you have a question about the Viavi T-BERD 8000 and is the answer not in the manual?
General| Brand | Viavi |
|---|---|
| Model | T-BERD 8000 |
| Category | Test Equipment |
| Language | English |
Explains the guide's purpose and scope for using MTS/T-BERD features and capabilities.
Details how to insert and remove modules into the T-BERD/MTS 8000 V2 and T-BERD/MTS-6000/6000A platforms.
Details how to configure the unit for Smart Test, including selecting configuration files and modifying parameters.
Guides on launching an OTDR measurement after configuring acquisition and file storage parameters.
Guides on selecting and configuring the RDZ function by pressing HOME, then the RDZ OTDR icon, and finally the SETUP button.
Outlines the steps to launch an acquisition after configuring the measurement.
Explains how to activate the power meter function and access measurement parameters via the SETUP key.
Guides on how to perform power level measurements by connecting the light source and using the START/STOP key.
Describes how to perform insertion loss measurements using a light source and power meter after carrying out a reference measurement.
Guides on accessing the OEO configuration menu by pressing SETUP on the Platform 8000.
Details the steps for performing automatic bi-directional measurements, including process display, curves, and summary.
Provides solutions for common errors and warnings encountered during bi-directional measurements.
Explains the necessity of referencing leads/patch cords for meaningful measurements and describes reference methods.
Guides on configuring acquisition parameters after taking references on both 8000 V2 units.
Guides on activating the PMD function and performing auto-calibration status check via RESULTS button.
Lists applicable modules and sources for PMD measurements and outlines remote operator procedures.
Details how to activate the IPMD function and configure acquisition parameters.
Recommends performing a Zero Referencing before first use for High OSNR accuracy.
Guides on installation and performing an In-Band PMD-OSNR measurement using I-PMD and PSM modules.
Guides on configuring the instrument by pressing SETUP and selecting OSA-icon or function icon.
Guides on validating the AP function and performing auto-calibration status check via the RESULTS button.
Recommends performing broadband source referencing daily or after changing patchcords for AP measurements.
Outlines the procedure to make a measurement after reference is completed, including connecting fiber and pressing START/STOP.
To Next Page