Vibe BlackDeath Series User Manual

BlackDeath Bass 2
Model: BLACKDEATHBASS2-V1
To ensure maximum
performance and safety,
please follow this manual.
Please retain the manual
for future reference after
installation
www.vibeaudio.co.uk
IN
ST
R
UC
TI
O
N
MAN
U
A
U
U
L

Vibe BlackDeath Series Specifications

General

Speaker Size	6.5 inches
Frequency Response	45Hz - 25kHz
Impedance	4 Ohms
Mounting Depth	2.8 inches
Woofer Size	6.5 inches
Magnet Type	Ferrite
Configuration	2-Way Component

Summary

Owners Manual

Attention

Highlights the significant electrical load of the amplifier and the need for upgrades for proper operation.

Power Connections

Terminals and Connections

Power Input 1

Details on using 0 gauge cable, inline fuse placement, and bulkhead requirements for power connection.

Speaker Output Terminal

Connection point for speakers, with references to wiring examples on pages 8 and 9.

Low Level Input

Connection for any source with a low-level output, typically RCA output from the headunit.

Low Level Output

Power / Protect LED

Gain Control

Matches the input signal of the source to the amplifier's sensitivity.

Subsonic Filter Control

Bass Boost Level Control

Bass Boost Frequency Control

Low Pass Crossover Control

Phase Control

Remote Gain Input Socket

Socket for plugging in the supplied remote bass level controller.

Input Mode Select Switch

Used to select between MASTER or SLAVE input mode.

Slave Input / Output

Set Up Section

Limited Warranty

Warning

Warns about high sound pressure levels potentially causing permanent hearing damage.