27
Maintenance Chart
Features Requirements
Before Use
After Use
Refuelling
Monthly
Yearly
If damaged
As required
Trimmer
Visual inspection (leaks)
Throttle lever
Check operation
Throttle trigger
interlock
Check
Stop switch
Check
Fuel tank
Clean Outside
Cutting Head Assy
Check & clean
Gearbox
Grease (straight shaft)
Air filter
Check
Clean
Replace (Depending on conditions)
Cowling
Clean
Cylinder fins
Clean
Spark plug
Clean & readjust gap
Nylon Line
Stock replacement
Cast Trimmer Head
Clean
Replacement
All accessible fasteners
Retighten
Muffler
Inspect
Inspect spark arresting screen
Clean or replace
Always stop the engine before any maintenance is done on the unit.
When all parts have stopped rotating, remove the spark plug lead to
begin maintenance work.
Never repair cutting attachments by welding, straightening or
changing the shape. This may result in serious injury.
Never attempt maintenance that is not outlined in this manual. All
repair work must be carried out by a VICTA Authorised Service Centre.
Refer to the following table for routine maintenance.
•
•
•
•
•
••
•
•
••
•
•
•
•
••
••
•
•
••
•
•
•
•
•
••
•
•
To Next Page
Loading...
Need help?
General
