Victor M241 - Cleaning Electronic Rat Trap; Cleaning; Step-by-Step Cleaning Instructions

Cleaning: Electronic Rat Trap (M241)
Cleaning
Cleaning is an essential part of trap maintenance. Proper cleaning ensures that your
Victor® Electronic Rat Trap continues to successfully function and eliminate your
rodent problems! Follow our step-by-step cleaning instructions to keep your trap
working like new.
STEP-BY-STEP INSTRUCTIONS
1. Turn the trap OFF, then remove the batteries. Open the trap by holding the
base of the trap with your left hand and sliding the top backwards with your
right hand about one inch. Pull the top away from the base.
2. The kill chamber is now ready for cleaning. Use a hydrogen peroxide topical
solution (available at most drug stores) and an old toothbrush to clean the
inside of the chamber. Use a wire brush as needed to remove any corrosion,
being careful not to be too vigorous. This could accidentally remove all of
the protective zinc plating.
3. Thoroughly dry the interior and exterior of the kill chamber prior to trap
reassembly.
4. To reassemble trap, hold the base of the trap with your left hand and slide
the top into place by pushing forward with your right hand to reconnect the
pieces.
5. The trap is ready for use.