10
ability for use in contact with water for human consumption. The installer must Make the hydraulic
connections respecting the rules of hygiene and water safety to environmental protection in force
in the place of installation. So for the hydraulic plant contact an authorized technician. Always utilise
the new hose supplied for connection to the water supply. Old hoses must not be utilised.
• On installation, the qualified electrician must fit a circuit breaker switch as foreseen by the safety
norms in force that has a contact open distance that permits the complete disconnection under
conditions of overload category III, which must be installed in the power supply system in accord-
ance with the wiring regulations. For the Australian and New Zealand markets, the disconnector
must be installed in accordance with AS/NZS 3000.
• In case of installation in kitchens, connect the equipotential conductor to the terminal on the machine
indicated by the symbol
.
• It is advisable to install a mains earth leakage circuit breaker with a rated differential current not exceed-
ing 30mA.
• The manufacturer cannot be held responsible for any damages incurred if
the system is not grounded. For electrical safety, this machine requires a
ground system. Contact a technically certified electrician who must check
that the line electrical capacity is adequate for the maximum capacity indi-
cated on the unit label.
• There are some basic rules for the use of any electrical appliance. In particular:
• Never touch the unit with wet hands or feet;
• Never use the unit with bare feet;
• Never use extension cords in areas equipped with baths or showers;
• Never pull on the power supply cord to unplug the unit;
• Never leave the unit exposed to atmospheric agents (rain, direct sunlight, etc..);
• Never let children, unauthorized personnel or anyone who has not read this manual operate the
unit.
• The qualified electrician must also check that the section of the installation’s cables is large enough
for the absorbed power of the appliance.
• Never use adapters, multiple jacks or extension cords. When such items prove absolutely necessary,
call in a qualified electrician.
• To prevent dangerous overheating, it is advisable to fully extend the power supply cord. Never block
the intake and/or heat dissipation grills, in particular those for the cup warmer.
• The user must never replace the unit’s power supply cord. If this cord is damaged, turn off the unit
and have it replaced by a professionally qualified technician.
• Should it be necessary to replace the power cord, this replacement operation must only be per-
formed by an authorized service centre or by the manufacturer.
To Next Page
Need help?
General
