Victory Tornado - Installation

Page11
Installation (Continued)
Figure9
Figure 8
Figure7
Figure10
5. Storeexcesswiresinthewiringbox.
6. Dropoiltunnelintorecesssupportnearrearofhood.RefertoFigure9.
7. Toinstallbafeltersandstainlessspacer(s),refertoBafe Filters and Stainless Steel SpacersonPage18forbafe
lterandstainlessspacerplacement.RefertoFigure10forthefollowingvesteps:
Anglebafeltertowardbackofhood.
Pushbafelterupuntilalmostlevel.
Slideforwardintorecessbehindthefrontofhood.
Lowerbafelter.
Slidebackuntilittsintorestingpositions.
9. RepeatStep8toinstallallbafeltersandstainlessspacers(ifany).
10. OPTIONAL: Install heating lamps (not included) last. 120-Volt, 250-Watt maximum per lamp.
11.TurnpoweONincontrolpanel.Checkalllightsandfanoperations.
12.MakesuretoleavethisInstallationGuideforthehomeowner.