Victory Tornado - Maintenance; Filter Cleaning and Replacement; Light Bulb Replacement

Page20
WARNING
Hazard of Burns!
Light bulb become extremely hot when turned on.
DO NOT touch bulb until switched off and cooled.
Touching hot bulbs could cause serious burns.
Align arrows on both rings
Maintenance
SAFETY WARNING: Never put your hand into area housing the fan while the fan is operating!
Foroptimaloperation,cleanrangehoodandallbafe/spacer/lter/greasetunnel/oilcontainerregularly.Regularcarewill
help preserve the appearance of the range hood.
Cleaning Exterior surfaces:
• Cleanperiodicallywithhotsoapywaterandcleancottoncloth.Donotusecorrosiveorabrasivedetergent(e.g.Comet
PowerScruv
®
, EZ-Off
®
ovencleaner),orsteelwool/scoringpads,whichwillscratchanddamagethestainlesssteel
surface.Forheaviersoiluseliquiddegreasesuchas“Forumla409
®
”or“Fantastic
®
” brand cleaner.
• Ifhoodlookssplotchy(stainlesssteelhood),useastainlesssteelcleanertocleanthesurfaceofthehood.Avoidgetting
cleaning solution onto or into the control panel. Follow directions of the stainless steel cleaner. CAUTION: Do not
leave on too long as this may cause damage to hood nish. Usesofttoweltowipeoffthecleaningsolution,gently
ruboffanystubbornspots.Usedrysofttoweltodrythehood.
• Aftercleaning,youmayusenonabrasivestainlesssteelpolishsuchas3M
®
orZEP
®
, to polish and buff out the stainless
lusterandgrain.Alwaysscrublightly,withcleancottoncloth,andwiththegrain.
• DO NOT allow deposits to accumulate or remain on the hood.
• DONOTuseordinarysteelwoolorsteelbrushes.Smallbitsofsteelmayadheretothesurfaceandcauserusting.
• DO NOT allow salt solutions, disinfectants, bleaches, or cleaning compounds to remain in contact with stainless steel
forextendedperiods.Manyofthesecompoundscontainchemicals,whichmaybeharmful.Rinsewithwaterafterex-
posureandwipedrywithacleancloth.
Cleaning Aluminum Grease Filter / Stainless Steel Filterless Grill:
IMPORTANT:Drainoilfromoilcontainersbeforeoilandresidueoverow!
• Themetalltersttedbythefactoryareintendedtolteroutresidueandgreasefromcooking.Itneednotbereplaced
onaregularbasisbutarerequiredtobekeptclean.
• Filtersshouldbecleanedafterevery30hoursofuse.
• Removeandcleanbyhandordishwasher.Spray“Formula409
®
”orequivalentdegreasingdetergentandleavetosoak
ifheavilysoiled.Dryltersandre-installbeforeusinghood.
Replacing Filters:
• Shouldlterswearoutduetoageandprolongeduse,pleasecontactyourlocalresellerforreplacementlters.
• Note:Alsoreplacedamagedlterthathaspuncturedorbrokenmesh,bentorbrokenframe.
Replacing the light bulb:
• ThisrangehoodusesLEDorhalogenbulb(pleaserefertotheactualspecicationofthehoodpurchased):
 USA/Canada: Halogen35WTypeGU10120V
 USA/Canada: LED3WTypeGU10120V
• MakesuretherangehoodisunpluggedorturnOFFbreaker.
• Makesurethelightsarecooltotouch,carefullyalignthearrowonthein-
nerringwiththearrowontheouterringwhereitsaysOPEN.Theinner
ringwillloosenandthelightbulbwillbeavailableforremoval.Installa
new halogen light bulb and reverse the steps.
• TurnONbreakerandrangehoodtotestforoperation.