Victron energy Phoenix 12-180 User Manual (English)

Questions and Answers:

E
efrazierAug 1, 2025
How to troubleshoot a Victron energy Inverter that is not working (LED OFF)?
- J
  jacksonjillianAug 1, 2025
  If your Victron energy Inverter is not working and the LED is off, first check if the power switch is in the OFF position and push it to the ON position. Poor contact between the inverter’s battery wires and the battery terminals can also cause this, so clean the terminals or wire contacts and tighten the screws. If these steps don't work, the inverter fuse may be blown, requiring the inverter to be returned for service, or the battery condition may be very poor, necessitating a battery replacement.
R
Richard EllisAug 9, 2025
Why does my Victron energy Phoenix 12-180 Inverter keep showing ‘Battery voltage too low or too high’ error?
- S
  Susan LopezAug 9, 2025
  If the Victron energy Inverter shows a ‘Battery voltage too low or too high’ error, it could be due to several reasons. The battery might be in poor condition, requiring replacement or charging. There could be a poor connection or inadequate wiring between the battery and inverter, leading to excessive voltage drop; use a wire gauge approximately 1.5 times larger than the inverter's fixed battery wires when extending them, and avoid extensions longer than 3 meters. Alternatively, there might be a general failure in your electrical system, in which case you should check your electrical system or consult an electrical engineer.
C
Craig HebertAug 17, 2025
What to do if Victron energy Phoenix 12-180 shows ‘Overloaded or shorted output’ error?
- M
  moranmarcusAug 17, 2025
  If your Victron energy Inverter displays an ‘Overloaded or shorted output’ error, it means that the inverter is overloaded. Ensure that the total power rating of the connected equipment is less than the inverter's nominal power rating. Another possible reason is that the connected equipment has a bad power factor; you can reduce the required power consumption of the load. Also, the equipment connected could be causing a short circuit at the inverter’s output, so make sure that the connected equipment is not broken or malfunctioning and check the AC power cord for any physical damage.
A
Alison ElliottAug 25, 2025
How to fix ‘Inverter temperature too high. Cooling down’ error on Victron energy Inverter?
- R
  Raymond SotoAug 25, 2025
  If your Victron energy Inverter shows ‘Inverter temperature too high. Cooling down’ error, the airflow around the inverter could be obstructed. Ensure there is at least 10 centimeters of clearance around the inverter, remove any items placed on it, and keep it away from direct sunlight or heat-producing equipment. Alternatively, the ambient temperature might be too high, so move the inverter to a cooler place or provide additional cooling with an external fan.

Victron energy Phoenix 12-180 Specifications

General

Input Voltage	12 V
Output Voltage	230 VAC
Continuous Output Power at 25°C	180 VA
Output Frequency	50 Hz or 60 Hz
Model	Phoenix 12/180
Transfer Time	Not applicable
Protection	Output short circuit, Over temperature
DC Input Voltage Range	9.5-17V