What to do if my Victron Energy Control Systems battery voltage setting is too high?
If the battery voltage setting is too high, check the “battery voltage” setting using the VictronConnect App or a connected display.
What to do if my Victron Energy Control Systems battery voltage setting is too low?
If the battery voltage setting is too low, check that the battery voltage is set properly in the settings of the solar charger.
What to do if my Victron Energy Control Systems charger is disabled?
If the charger is disabled, verify in the VictronConnect app that the charger has been enabled.
Why is my Victron Energy Control Systems battery charge current too low?
If the battery charge current is too low, check the “Max charge current” setting in the VictronConnect app or via the display.
What to do if there is a battery supply issue in Victron Energy Control Systems?
If you're experiencing a battery supply issue, consider these possible causes and solutions: 1. **Loose or missing battery cables:** Ensure all cabling is connected correctly. 2. **Loose cable connections or badly crimped cable terminals:** Verify that all cable connections are tight, considering maximum torque levels. 3. **A blown (or missing) fuse in the battery supply cable:** Inspect fuses and/or circuit breakers. 4. **Open (or faulty) circuit breaker in the battery supply cable:** Check fuses and/or circuit breakers. 5. **Missing or incorrectly wired battery cables:** Verify the integrity of the battery wiring.
What to do if my Victron Energy Control Systems batteries are not charged?
If your batteries are not charging, consider the following potential causes and solutions: * **Issues with the battery, PV panels, or system wiring:** Check the VictronConnect app for a clickable link that says “why is the charger off”. * **Incorrect settings:** Review and adjust the settings. * **External control:** Verify in the VictronConnect App if external control is active. * **Natural battery behavior:** Examine the current state of the battery.
Why is my Victron energy SmartSolar MPPT 150/35 not fully charging the battery?
If the Victron energy Controller is not fully charging the battery, there are several potential causes. First, check the battery connection to ensure it is secure. High cable losses can also prevent full charging; use cables with a larger cross-section to reduce these losses. A large ambient temperature difference between the charger and battery can also affect charging; ensure that ambient conditions are equal for both. For 24V or 48V systems, verify that the correct system voltage has been selected on the charge controller; if not, manually set it to the required voltage.
General| Brand | Victron energy |
|---|---|
| Model | SmartSolar MPPT 150/35 |
| Category | Controller |
| Language | English |
Specifies charge current up to 35A and PV voltage up to 150V.
Details the benefits of ultra-fast MPPT for improved energy harvest.
Warning regarding the risk of explosion from sparking.
Warning concerning the potential for electric shock.
Provides solutions for common causes when the charger does not operate.
Addresses troubleshooting for incomplete battery charging issues.
Offers solutions for problems related to battery overcharging.
To Next Page