VIDEOJET 1710 - Page 164

Rev AA Printer Status Icons 7-11
Videojet 1710 Operator Manual
Ink Core Service
Soon (2% left)
Ink core module nearing end of service
life.
2% life is equal to 80 hours for 1710.
Contact Videojet maintenance engineer.
Ink core service
soon (5% left)
Ink core module nearing end of service
life.
5% life is equal to 200 hours for 1710.
Contact Videojet maintenance engineer.
Product Delay Too
Short
Contact Videojet maintenance engineer.
Inter-print Gap Too
Short
Insufficient time to compile between
prints. Contact Videojet maintenance
engineer.
Print Queue Too
Deep
Too many products between PEC and
the printhead. Contact Videojet
maintenance engineer.
Print Overlap Print starts before end of current print.
Contact Videojet maintenance engineer.
No Time to Phase Contact Videojet maintenance engineer.
No time for TOF The printer is unable to get an “actual
velocity” and thus cannot perform TOF
velocity control.
Overspeed The Shaft encoder speed is very high to
get the print width that you need. If the
print width is not acceptable, report the
fault to a maintenance engineer.
- Maximum Print
Rate Exceeded
Contact Videojet maintenance engineer.
- No Valid Ink
Parameters
Contact Videojet maintenance engineer.
Icon Name Remedial Action
Table 7-5: Warning Icons (Continued)