Rev AA Electrical Safety Guidelines 2-3
Videojet 1710 Operator Manual
Electrical Cables
PERSONAL INJURY. Use only the main power cable supplied with
the printer. The end of this cable must have an approved, three-pole,
main plug that has a protective ground conductor.
The electrical power cables, sockets and plugs must be kept clean
and dry.
For pluggable equipment, the socket-outlet must be installed near
the equipment and must be easily accessible.
PERSONAL INJURY. Always inspect the cables for damage, wear,
corrosion, and deterioration. Make all grounding/bonding
connections void of areas of paint, ink build-up, and corrosion.
Grounding and Bonding
PERSONAL INJURY. The printer must be connected to an AC
power supply that has a protective ground conductor and must be
according to IEC requirements or applicable local regulations.
PERSONAL INJURY. Do not use the printer if there is any
interruption in the protective ground conductor or if the protective
ground conductor is disconnected. The failure to follow this warning
can cause an electrical shock.
To Next Page
Loading...