Using the Keyboard
3-20
READY Light
The READY light indicates whether or not the printer is ready to
print a message (whenever a product detect signal is received).
The READY light turns On only when the lights on both the
HEAD key and PRINT key are On.
READY Light Summary
=
Light is On (green):
This indicates that the printer is ready to
print a message onto the product whenever a product detect
signal is received.
Light is Off:
This indicates that the printer is not ready to print a
message. To make the printer ready to print a message, press
the
HEAD
key (if the light on the
HEAD
key is Off), then press
the
PRINT
key. If the
HEAD
key light is already On, press the
PRINT
key. This will cause the
READY
light to turn On.
SERVICE Light
If the SERVICE light is flashing, it indicates that a printer
fault
has occurred. When a fault occurs, the fault type is displayed on
the screen. Call a qualified service technician to determine the
nature of the fault and to correct the condition as required.
If the SERVICE light is lit (not flashing), it indicates that a printer
warning
has occurred. When a warning occurs, information about
the warning is displayed on the screen. Warning conditions are less
serious than fault conditions, but in most cases will become a fault
condition if not corrected. Call a qualified service technician to
determine the nature of the warning and to correct the condition as
required.
SERVICE Light Summary
=
Light is On (yellow):
This indicates that the printer has
experienced a warning condition.
Light is Flashing (yellow):
This indicates that the printer has
experienced a fault condition.
Light is Off:
This indicates that the printer is operating normally
(without any problems).
To Next Page