Edit Suite Version 2.01 (MANL-0588-02) 6
7. IR Tables To make room for the above tables, several IR tables have been replaced
in this release. (Both the old tables and the replacement tables were
available previously.) If you previously used one of the "old" tables,
switch to the "new" table for this release.
Old Table New Table Old Table New Table
003 105 036 115
013 110 037 116
014 104 039 117
015 106 040 118
016 109 041 119
017 107 046 120
019 111 047 121
021 103 050 122
022 112 056 123
024 113 058 127
026 101 059 124
029 102 060 125
035 114 061 126
064 128
C. Change to GPI Trigger Signal
To add support for some GPI devices (such as JVC titlers) that were not supported in previous
versions of Edit Suite, we changed the GPI trigger signal. The width of the trigger pulse was
shortened (from 100ms to 50ms) and the GPI now initializes high and pulses low. All devices that
worked previously will work with the new settings and devices that failed to trigger previously should
now trigger satisfactorily.
To Previous Page
Loading...