Videonics AB-1 Edit Suite - Communication Programs and Settings

Communication Programs and Settings
Edit Suite can communicate with most communication software programs that support XOn/XOff
Flow Control. The table on the following page identifies three communication programs we have
tested with Edit Suite, and the settings for each. Adapt these settings to your software package.
Communication Programs and Settings
Computer Macintosh PC DOS PC Windows
Communications Program MicroPhone II ProComm Terminal
Communications Menu
Method
Driver
Baud Rate
Data Bits
Parity
Stop Bits
Flow Control
Parity Check
Carrier Detect
Microphone Std.
Standard
19,200
8
None
1
XOn-XOff
Press Alt-P and
select table 12.
19,200
8
None
1
19,200
8
None
1
XOn-XOff
(blank)
(blank)
Text Transfer
End Outgoing Lines with:
Save Text As:
Wait for Echo
Flow Control
CR
Teach Text
None
Standard
ASCII Transfer
Echo Local
Expand Blank Lines
Pace Characters
Character Pacing
Line Pacing
Down Loading
CR
LF
Up Loading
CR
LF
Press Alt-S,
select menu 6.
Yes
Yes
0
23
11
None
None
None
None
Terminal Emulation
DEC VT-100 or DEC VT-52
Terminal Preferences
Line Wrap
Local Echo
Sound
CR->CR/LF
Inbound
Outbound
X
X
X
(blank)
(blank)
Transfer/Send Menu
Protocol
ASCII/Text
Ensure that all settings are correct before you begin communicating with Edit Suite. Test by running
Edit Suite's Export function without saving the data that is sent. You should see 255 lines of 32
characters per line scroll down your PC display. If not, either some of the above values are not set
properly or your modem/communications port is not configured for computer-to-computer
communications. Consult your PC or communication manuals for more information.