A. SELECT A SOURCE TO USE: Press the A, B, C or D key for one of the
sources you were able to control. (The A, B, C, and D keys are called the
VCR Selector keys.)
B. POSITION THE TAPE: Use the jog/shuttle or transport keys to move the
tape at least 45 seconds or one minute from the start of the tape.
C. CREATE A SCENE EVENT: Press and hold the [SHIFT] key, then tap the
[IN] key. A Scene Event for the current source is created (left figure). This
is the first event in your EDL (Edit Decision List). "001" is the event
number; "A" is the VCR port. The time is the time that was current on the
VCR when [SHIFT]+[IN] was pressed.
001 IN 00:05:22.04
A OUT : : .
D. ADJUST THE IN TIME: Use the transport keys or the jog/shuttle to
move the tape to a new location. While you do this the Scene Event is
replaced by the Live VCR display. The Live Display shows the current
source and the current time code. (If you want to see the Scene Event
again, press [OK].)
VCR PANA
00:05:24.00
001 IN 00:05:24.00
A OUT : : .
Live VCR Display Scene Event
Press [IN]. Edit Suite updates the value in the IN field to the VCR's current
time.
E. ADD AN OUT TIME: Move to an end position for the scene and press
[OUT]. Edit Suite adds the current tape address to the OUT field of the
active event.
001 IN 00:05:24.00
OUT 00:05:35.20
F. CREATE A SECOND EVENT: Press [SHIFT]+[IN] again to create a
second event. Adjust the IN and OUT times by positioning the tape and
pressing [IN] or [OUT].
G. SEARCH TO A POINT ON THE TAPE: This step has nothing to do with
creating an A/A Roll, but it's a function you should know exists. You can
have Edit Suite search to the IN or OUT point of any event by displaying
the event and pressing [GO TO]+[IN] or [GO TO]+[OUT]. Try it.
To Next Page
Loading...