VideoSecu ML531BEV3 User Manual

Installation Instruction
Tools Needed for Assembly
Stud finder (for wood stud wall)
Pencil Mark
Electric drill
Drill bit (for wood stud wall)
Masonry drill bit (for concrete wall)
Ratchet
Measuring tape
Phillips screwdriver
Wood Stud Wall Installation
Step 1. Locate the Wood Studs
Wall studs run vertically (up and down) inside the wall, behind the
drywall or plaster. The wall plate must be mounted to wood stud.
1-1. Using an awl, a thin nail, a small drill bit, or an edge to edge stud finder,
1-2. Mark the centerline of the stud.
Step 2. Drill Pilot Holes
2-1. Hold the wall plate so the holes line up with the stud center lines.
2-2. Level the wall plate and mark the mounting hole position.
2-3. Drill a pilot hole at the marked location using a power drill
and a 5/32” drill bit.
Visit our website at www.VideoSecu.com © 2016 VideoSecu.com
Use a qualified professional to properly install. VideoSecu is not liable for the improper use or installation of
its products. Hardware provided is for mount through standard thickness drywall into wood studs, or mount to
solid concrete wall. Installers are responsible to provide hardware for other types of mounting situations.
For metal stud wall or other hollow wall installations, toggle bolt anchors can be purchased from your local
hardware store, consult a specialist at your local hardware store for select and use special anchors.
Level
drill depth
2-1/4”
drill bit diameter
5/32”
1
finds the edges of the stud.
STUD
Step 3. Mount Wall Bracket
Using the provided lag bolts, tighten
each bolt with a socket wrench. Do
not use power drill and do not over
tighten the lag bolts.
ST6.3×65
Self-tap screw
M6 Flat washer
STUD

VideoSecu ML531BEV3 Specifications

General

Brand	VideoSecu
Model	ML531BEV3
Category	TV Mount
Language	English

Summary

Wood Stud Wall Installation

Step 1. Locate the Wood Studs

Locate wall studs vertically behind drywall or plaster for mounting the wall plate.

Step 2. Drill Pilot Holes

Align wall plate with stud centerlines, level, mark holes, and drill pilot holes.

Step 3. Mount Wall Bracket

Use provided lag bolts to tighten the wall bracket securely without over-tightening.

Step 4. Remove the TV Plate from the Bracket

Separate the TV plate from the main mount by unscrewing the side screws.

Step 5. Insert the plastic covers

Insert the two provided plastic covers onto the wall plate.

Step 6. Attach TV plate to the TV or Monitor

Attach the TV plate to the TV using appropriate screws and washers.

Step 7. Hang the TV to the Wall Plate

Hang the TV onto the wall bracket and securely fix the lock nut.

Step 8. Adjusting the TV display

Adjust TV location by tilt and swivel, manage cables, and set tension.

Concrete Wall Installation

Step 1. Drill Mounting Holes

Mark and drill holes in the concrete wall for mounting the screen.

Step 2. Install Anchors

Insert plastic concrete anchors into drilled holes and tap flush.