8- FAILURE LOCATION GUIDE
EQUIPMENT WITH LOW EFFICIENCY
Check:
b) Remove the water hose from the evaporator.
3
c) Using a container with a cm scale on it, turn on the pump and
3
collect the water for one cycle, which should be between 800 cm
If the water collected is below the minimum, check that:
The evaporator hose is not obstructed, bent or kinked.
YES NO
WATER PUMP PERFORMANCE AND ELECTRICAL CONNECTIONS
(minimum) and 1500 cm3 (maximum).
a) Remove the upper cover.
The switch commanding the water cycle is properly set.
(See Water Cycle Setting before)
To Next Page
Loading...