Viessmann LB1 - Page 56

56
For description of parameters: See page 21.
Vitovent 200-C
Parameter Code Delivered condition Commission-
ing
Maintenance/
service
"Enable Vitovent" 7D00 0
"Enable electric preheating coil" 7D01 0
"Set extract air temperature" 7D08 240 (≙ 24 °C)
"Flow rate, reduced ventilation" 7D0A
75 m
3
/h
"Flow rate, nominal ventilation" 7D0B
115 m
3
/h
"Flow rate, intensive ventilation" 7D0C
155 m
3
/h
"Min. supply air temperature for bypass" 7D0F 160 (≙ 16 °C)
"Strategy, passive frost protection" 7D2C 0
"Type of heat exchanger" 7D2E 0
"Installation position" 7D2F 0
"Function, external 230 V input, ventila-
tion"
7D3A 0
"Duration, bathroom vent." 7D3B 30 min
"Starting block, ventilation periods part
1"
7D5E -28160
"Starting block, ventilation periods part
2"
7D5F 36
"Control voltage matching, supply air
fan"
7D71 0 V
"Control voltage matching, exhaust air
fan"
7D72 0 V
"Sensor matching, ODA temp down-
stream of preheat. coil"
7D76 0 K
"Sensor matching, supply air tempera-
ture"
7D77 0 K
"Sensor matching, extract air tempera-
ture"
7D79 0 K
"Continuous operatn ON/OFF" 7D83 2
"Duration, economy mode" 7D84 72 h
"Duration, intensive mode" 7D85 12 (≙ 120 min)
"Automatic changeover summertime -
wintertime"
7781 1
"Start summertime - month" 8682 3
"Start summertime - week" 8683 5
Start summertime - day 8684 7
"Start wintertime - month" 8685 10
"Start wintertime - week" 8686 5
"Start wintertime - day" 8687 7
Commissioning/service reports
Parameters
5816558
Appendix