Vitocrossal 300 CU3A 26 to 57 Operating
5673 650 - 01
30
Scanning
Scanning Information
Subject to the connected components and settings
made, you can scan current temperatures and operating
conditions.
The extended menu splits the information into groups:
H “General”
H “Heating circuit 1”
H “Heating circuit 2”
H “Heating circuit 3”
H “DHW”
H “Solar”
H “Reset data”
Note: If heating circuits have been named, the name is
displayed (see section “Entering names for the
heating circuits”). Detailed options for calling up
data on individual groups can be found in chapter
“Calling up options under information”.
Extended menu:
1.
2. “Information”
3. Select the group.
4. Select the required information.
Calling up the solar yield in conjunction with solar thermal
systems
Extended menu:
1.
2. “Solar energy”
The solar energy yield is shown in diagrammatic form.
The flashing line on the graph indicates that the current
day is not yet over.
Note: Further options for calling up data, e.g. for the
solar circuit pump hours run, can be found in the
extended menu under “Information” in the “Solar”
group.
Resetting data
You can reset the following data:
H Burner hours run.
H Fuel consumption.
H In conjunction with a solar thermal system:
Solar energy yield, solar circuit pump hours run and
hours run output 22.
H All the above data simultaneously.
Extended menu:
1.
2. “Information”
3. “Reset data”
To Next Page
Loading...
Need help?
General
