-17-
4) Replace the fuse with the provided spare or equivalent as specified below.
5)
Simply return it with the fuse holder to the socket. Push and turn it a
quarter clockwise to lock.
12. Basic Trouble Shooting
Note : Risk of electric shock. Always disconnect the power cord from the
wall and the instrument prior to performing any of the following procedures.
Do not touch the projector with wet hands.
■ If the instrument does not function at all:
1) Check the facility power source. (Circuit Breakers)
2) Check the electrical connections. (Power Cord)
3) Check the main fuse located on the rear of the unit.
■ If the projector lamp does not light(Ask the manufacturer or service person for help):
1) Check the main On/Off Switch.
2) Replace the lamp with the spare lamp.
The lamp may be HOT! Do not touch the Lamp directly and allow the
sufficient amount of time to cool down the heat.
■ If the projector turns on but does not function:
1) Check the batteries in the remote control.
13. Transportation
■ Make sure the instrument is disconnected from the power source.
■ If the instrument was installed on a custom mount, please remove the unit from the
mount.
■ Pack the instrument in a sturdy carton with suitable packing materials.
■ After packing, do not hurl and impact cause of breakable goods.
- Do not use this machine near by other machines or electric bulb (ex. Halogen lamp),
it will improperly operate on the effect of electronic waves.
VOLTAGE FUSE
100V ~ 240V 1A 250V ; T1AL
To Next Page
Loading...