ViewSonic DSM3210
28
ENGLISH
•
Input Block: To set the input source to be blocked. Users will not be able to watch the
content coming from the blocked input source.
Use ENTER button to block the input source, and press ENTER again to unblock.
•
Change Password: To change the password, press ENTER, and the following screen
appears.
Enter the new password from the remote control, and then enter the new password again
to confirm.
Note:
Please make sure you remember your new password after changing, because you
cannot recall the default setting of the password by any selection.
•
Clear All: To clear all the locks set before, press ENTER, and then select “OK” to confirm.
To Next Page
Loading...
