ViewSonic E95 - Input Requirements

2. Input requirements
2.1
2.2
2.3
AC power supply.
2.1.1 Power source : 90~264VAC, 50/60Hz.
2.1.2 Power consumption __: Less than 130W (E95-1).
2.1.3 Inrush current : Less than 40Ao-p for 1/2 cycle on cold starting.
2.1.4 Input current : 3A max.
2.1.5 Leakage current :0.75mA at AC 100V/240V.
2.1.6 Ripple / noise : Should not cause any visible interference.
2.1.7 Power cable / color : 1.83 meter / match with cabinet.
(R)M model: 3-prong NEMA 5-1 5P type plug
E model : Shuko CEE7-7
Video interface.
2.2.1 RGB video : Analog, 0.7Vp-p, positive, input impedance 75ohm.
2.2.2 Max PC video signal : 950mV with no damage to monitor.
2.2.3 Max MAC video signal : 1250mV with no damage to monitor.
2.2.4 Sync signal : Separate or composite horizontal and vertical sync (TTL level).
2.2.5 Signal cable / color :1.83 meter ivory PC99 / match with cabinet.
2.2.5 Input connector :
15 pin mini “D” sub :
'
Pin No. Signal Pin No. Signal
1 Red 9 NC
2 Green 10 Ground
3 Blue 1] Ground
4 Ground 12 SDA
5 Ground 13 H. Syne
6 R Return 14 V. Sync
7 G Return 15 SCL
8 B Return
2.2.6 Signal memory modes: 13 preset modes
18 user modes, see Appendix A.
2.2.7 Plug & play : VESA DDC1 / 2B, DDC data Appendix B.
2.2.8 Input signal timing compatibility : VESA GTF
Scanning frequency.
2.3.1 Horizontal : 30KHz to 95KHz
2.3.2 Vertical : 50Hz to 180Hz