ViewSonic EP5540T User Manual

i
Compliance Information
NOTE: This section addresses all connected requirements and statements regarding regulations.
Confirmed corresponding applications shall refer to nameplate labels and relevant markings on
unit.
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class A/
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his/her own
expense.
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
Warning: To comply with the limits for the Class A/Class B digital device, pursuant to Part 15 of
the FCC Rules, this device must be installed in computer equipment certified to comply with the
Class A/Class B limits. All cables used to connect the computer and peripherals must be shielded
and grounded. Operation with non-certified computers or non-shielded cables may result in
interference to radio or television reception. Changes and modifications not expressly approved by
the manufacturer could void the user’s authority to operate this equipment.
For Canada
CAN ICES-3 (A/B)/NMB-3(A/B)

ViewSonic EP5540T Specifications

General

Package depth	618 mm
Package width	983 mm
Package height	2016 mm
Package weight	85000 g
RMS rated power	20 W
Number of built-in speakers	2
DVI port	No
USB version	2.0/3.2 Gen 1 (3.1 Gen 1)
USB ports quantity	4
Ethernet LAN (RJ-45) ports	1
Panel life	30000 h
Response time	6 ms
Display diagonal	54.6 \
Display brightness	400 cd/m²
Display technology	LED
Native aspect ratio	16:9
LED backlighting type	Direct-LED
Contrast ratio (typical)	1200:1
Cables included	AC
Internal memory	2 GB
Computer system type	System on Chip (SoC)
Internal storage capacity	16 GB
Operating system installed	Android 5.0.1
Purpose	Universal
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	20 - 80 %
Product color	Black
Product design	Interactive flat panel
Placement supported	Indoor
Certification	FCC/cTUVus/BSMI
AC input voltage	100-240 V
Power consumption (standby)	0.5 W
Power consumption (typical)	117 W

Weight and Dimensions

Depth	450 mm
Width	820 mm
Height	1900 mm
Weight	70000 g