ViewSonic LS832WU - Page 46

46
Menu Descripon
Image Sengs
Signal
Adjust the signal opons.
Seng Descripon
Automac
Automacally congure the signal
(Frequency and Phase will be grayed
out). If Automac is disabled,
Frequency and Phase can be then be
adjusted.
Frequency
Change the display data frequency
to match the frequency of your
computer’s graphics card. Use this
funcon only if the image appears to
icker vercally.
Phase
Synchronize the signal ming of the
display with the graphics card. If the
image appears to be un stable, use
this funcon to correct it.
H. Posion
Adjust the horizontal posioning of
the image.
V. Posion
Adjust the vercal posioning of the
image.
NOTE: This menu is only available if the input source is
RGB/Component.
Brightness Mode
Mode Descripon
Dynamic Black
Automacally adjust the picture
brightness in order to give opmum
contrast performance.
Eco
Dim the light output, lowering
power consumpon.
Constant Power
Select the power percentage
(20%~100%) for brightness mode.
Reset
Return current display mode sengs (Brightness, Contrast,
Sharpness, Color, Tint, Gamma, Brilliant Color™, Color
Temperature, Color Matching, RGB Gain/Bias, Color Space,
Brightness Mode, Signal sengs) to default values.