What to do if ViewSonic LS900WU remote control does not work?
If your ViewSonic Projector's remote control isn't working, here are a few things to try: * First, replace the battery with a new one. * Make sure there's nothing blocking the path between the remote and the projector. * Ensure you're within 8 meters (26 feet) of the projector. * Finally, check and adjust the remote control code to ensure it's consistent with the projector.
How to fix ViewSonic LS900WU Projector that does not turn on?
If your ViewSonic Projector isn't turning on, consider these potential causes: * Ensure the power cord is securely plugged into both the AC inlet on the projector and a functioning power outlet. If the outlet has a switch, make sure it's on. * If you've recently turned the projector off, wait until the cooling down process is complete before attempting to turn it on again.
Why ViewSonic Projector has no picture?
If your ViewSonic Projector displays no picture, several factors could be the cause: * Ensure the video source is turned on and the signal cable is correctly connected. * Verify that the projector is correctly connected to the input signal device. * Confirm that the correct input signal is selected using the Source key on the projector or remote control.
Why is my ViewSonic LS900WU Projector image blurred?
If you're experiencing a blurred image with your ViewSonic Projector, here's what you can do: * Adjust the focus of the lens using the focus ring. * Make sure the projector and the screen are properly aligned by adjusting the projection angle, direction, and height of the projector if needed.
General| Resolution | WUXGA (1920 x 1200) |
|---|---|
| Light Source | Laser |
| Display Technology | DLP |
| Optical Zoom | 1.3x |
| Speakers | 10W |
| Projection Size | 30" - 300" |
| Input Lag | 16 ms |
| Warranty | 3 years |
| Brightness | 5000 lumens |
| Lamp Life | 20000 hours |
| Connectivity | HDMI, USB, VGA, RS232 |
| Digital Zoom | 2x |
| Lens Shift | Horizontal: ± 23% |
| Operating Temperature | 0 - 40 °C |
| Keystone Correction | Vertical ±40°, Horizontal ±40° |
To Next Page
