ViewSonic PerfectSound 29GA - Page 20

Multiple Monitor Option:
TV/V CR/Camera Video
You can connect up to 16 monitors together to display screen images from 1
to 3 video sources. Whatever video source is active on the first monitor will
be displayed on all monitors. To switch between multiple video sources, use
the Auto or Manual Input Select Buttons (see page 27) on the first monitor.
On every monitor, except the first, the input must be set to AV2, using the
Auto or Manual Input Select Buttons. The cables are not supplied for this
option.
You can connect two possible video sources to the first monitor in the chain,
using AV1 or AV2 video inputs. Connect the video output (AV OUT) of the
first monitor to the video input (AV2) of the next; continue this connection
pattern for each monitor. For composite video, use video cables with BNC
Connectors (not RCA Plugs). For s-video, use video cables with 4 Pin DIN
Plugs.
For multiple audio setup, make sure your audio source is connected with your
video source.
ViewSonic 29GA Installation | 17 :