ViewSonic PerfectSound 29GA - Page 24

15
16
17
used when connecting multiple
monitors (signal cable not
supplied).
BNC Video Output Connector:
This output (AV OUT) is for
video signal cable (not supplied),
used when connecting multiple
monitors.
Audio Output RCA Jack For
External Speakers:
This output is for connecting 8
ohm external speakers. When
using external speakers, slide the
Speaker Select Switch ( 7 ) to
"EXT".
Input Termination Switch:
ViewSonic 29GA
The normal position is to the left,
marked "75Q" (ohm). When you
connect multiple monitors (cable
not supplied), slide the switch to
"HI-Z" on the first monitor and on
every other monitor except the
last. On the last monitor in the
chain, the switch should be at
"75Q". You can connect up to 16
monitors.
Caution: When you are using
only one monitor, do not-set the
Input Termination Switch to "HI-
Z". The screen image will be too
bright.
Installation