ViewSonic PerfectSound 29GA - Page 28

3. Monitor Select
Switch (cont.)
MONITOR
SELECT
UU
4. Control Mode
Button
Mode Indicator
CONTROL MODE
SELECT
MODE 1
I
5. Mute Button
MUTE
1e)
ViewSonic 29GA
Monitor Monitor Select Monitor Monitor Select
No. Switch No. Switch
" UW? OL
we « UL
Remote Control Section for more information.
11
12
Note: You can control up to 16 monitors,
individually or all at the same time. See the
Press to toggle between Mode 1 and Mode 2.
Mode 1 is the default setting when the monitor is
activated. To select Mode 2, press the Control
Mode Button. The Mode Indicator will light green.
Mode 1: In this mode, you can adjust the
Brightness, Contrast, Color, Tint,
Sharpness, and Volume level. The Green
LED Mode Indicator is off in Mode 1.
(See page 28 for an explanation of these
controls.)
Mode 2: In this mode, you can adjust the
Monitor Image Size and Position, Side-
Pincushion and Trapezodial Distortion.
The Green LED Mode Indicator is on in
Mode 2. (See page 30 for an explanation
of these controls.)
Note: The monitor will automatically switch back
to Mode I approximately 60 seconds after the last
operation of any Mode 2 control.
Press to turn the sound off. Press again to turn the
sound on. When a Volume Control Button is
pressed, or the power is turned on and off, the
mute is reset to the sound on position.
Operation 25
aerne eS AiR ANE EE Me ae sete om