22
22
Black, Red, Green, Blue,
Cyan, Yellow, Magenta, White
Status Message
Information
Factory Default
Equivalent Lamp Hours
Equivalent Lamp Hours
Reset
Filter Hours*2
Filter Hours Reset*2
Input Password
Password Delete
Off, CC1, CC2, CC3, CC4,
T1, T2, T3, T4
Input Source
OSD Setting
OSD Timeout
Top-Left, Bottom-Left,
Top-Right, Bottom-Right
20 - 60
0, 10, 20, 30, 40, 50, 60, 70, 80, 90
OSD Transparency
Zoom
DCR
Test Pattern
Others
Swap
Display Type
Off, PIP, POP
Yes, No
On, Off
Function*3
On, Off
On, Off
Green Mode
*1 Adjustable range and default setting vary depending on signal type.
*2 This function is only available when the projector is installed an optional filter cover.
*3 The selectable Function list includes Color Mode, Gamma, Overscan, Noise Reduction, Keystone
and Filter Mode.
*4 Saturation is supported under Component, Video and S-Video modes.
*5 Sharpness is supported under HDMI, Component, Video and S-Video modes.
*6 Tint is supported under Component, Video and S-Video modes.
To Next Page
Loading...
