ViewSonic VA240A-H - Removing the Stand; Mounting the Monitor

11
Removing the Stand
1 2 3 4
1 2 3 4
IMPORTANT: Before removing the stand, turn o the monitor, disconnect all
cables, and place the monitor on a at, stable surface with the
screen facing down.
Mounng the Monitor
Aer removing the stand, the monitor can be mounted using an oponal mounng
kit.
NOTE: For use only with a UL cered mounng kit. To obtain a mounng kit or
height adjustment base, contact ViewSonic® or your local dealer.
Refer to the table below for the standard dimensions for mounng kits.
Maximum Loading Hole paern (W x H) Screw Specicaon Screw Quanty
14 kg 75 x 75 mm M4 x 10 mm 4
75 mm
75 mm
1. Aach the mounng bracket to the VESA mounng holes at the rear of the
monitor, securing it with four M4 x 10 mm screws.
2. Follow the mounng kit instrucons to mount the monitor.