Name: ViewSonic VA2746m-LED
Brand: ViewSonic
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Quick Installation

1. Connect video cable

• Make sure both the LCD display and computer are turned OFF.

• Remove rear panel covers if necessary.

• Connect the video cable from the LCD display to the computer.

Macintosh users: Models older than G3 require a Macintosh adapter. Attach the

adapter to the computer and plug the video cable into the adapter.

To order a ViewSonic

Macintosh adapter, contact ViewSonic Customer Support.

2. Connect power cord (and AC/DC adapter if required)

Power Cord

DVI

D-Sub

Audio In

3. Turn ON LCD display and computer

Turn ON the LCD display, then turn ON the computer. This sequence (LCD

display before computer) is important.

NOTE: Windows users may receive a message asking them to install the INF file.

To access the file, please use the directory ":\CD\vsfiles".

4. Insert the ViewSonic CD into the computer’s CD drive.

If your computer does not have a CD-ROM drive, please refer to Customer

Support page.

5. Windows users: Set the timing mode (example: 1024 x 768)

For instructions on changing the resolution and refresh rate, see the graphics

card’s user guide.

6. Installation is complete. Enjoy your new ViewSonic LCD display.

Additional Software Installation (Optional)

1. Load the ViewSonic CD on your CD/DVD drive.

2. Double click on the "Software" folder and choose an application, if desired.

3. Double click on the Setup.exe file and follow the onscreen instructions to

complete the simple installation.

Questions and Answers:

Need help?

Do you have a question about the ViewSonic VA2746m-LED and is the answer not in the manual?

ViewSonic VA2746m-LED Specifications

General