ViewSonic VG2248 H2 - Initial Setup; Wall Mounting

9
Inial Setup
This secon provides detailed instrucons for seng up your monitor.
Wall Mounng
NOTE: For use only with a UL Listed Wall Mount Bracket. To obtain a wall-
mounng kit or height adjustment base, contact ViewSonic® or your
local dealer. Refer to the instrucons that come with the base mounng
kit.
Refer to the table below for the standard dimensions for wall mount kits.
Maximum
Loading
Hole paern
(W x H)
Interface Pad
(W x H x D)
Pad Hole
Screw Specicaon &
Quanty
14 kg 100 x 100 mm 115 x 115 x 2.6 mm Ø 5mm
M4 x 10mm
4 pieces
NOTE: Wall mount kits are sold separately.
1. Turn o the device and disconnect all cables.
2. Place the device on a at, stable surface, with the screen facing down.
3. Aach the mounng bracket to the VESA mounng holes at the rear of the
device. Then secure it with four (4) screws (M4 x 10 mm).
100 mm
100 mm
4. Follow the instrucons that come with the wall mounng kit to mount the
monitor onto the wall.