ViewSonic VP730 - Page 26

5.3 . EDID Procedure
DDC User’s manual
1. Hardware installation
A. The EDID cable has equipped 2 different terminals;
one is male 25 pin printer connector and another side is male 15 pin D-sub connecter.
B. Connect the EDID cable from PC Printer port to monitor D-sub connector.
C. Make sure the monitor was working under power saving mode and keep it at “Power
Saving state” during DDC process.
D-Sub of
Monitor
15pin VGA
PC printer
port 25pin
connector
EDID-Kit
Cable
23
D o Not Copy V P730/bViewSonic Corporation Confidential