2. Programming procedure
A. Normally, you received a EDID zip file of new model. You need to unzipped it.
B. There will need the following files for DDC program: (VP730 is an example)
1. DPS.EXE
2. VP730.BAT
3. VP730.DDC
4. VP730.CFG
5. VP730.DPS
C. Execute the VP730.BAT (for VP730 monitor only) from Programming PC. Below screen will
display.
Fig-DDC1
Refer to Fig-DDC1; you have to select the required item if the display data was not you want.
Press 1: For year, the cursor will move to the column behind “Edit Year” than you can key in
the data you want after that press enter to exit and return. (It needs 4 numbers for this
data)
Press 2: For week, the cursor will move to the column behind “Edit Week” than you can key
in the data you want after that press enter to exit and return. (This data is within 1 ~ 53.)
Press 3: For S/N,, the cursor will move to the column behind “Edit S/N” than you can key in
the data you want after that press enter to exit and return. (This data is within 0 ~ 99999,
5 numbers max.)
24
D o Not Copy V P730/bViewSonic Corporation Confidential
To Next Page
Loading...
