D. Press “ESC” or “Enter” key to return main menu, the Fig-DDC2 will be displayed and the
correct serial number will show on right corner of screen.
Fig-DDC2
Under Fig-DDC2, you could change the “Week” data by press “*” key and the “S/N” data by press “-
“ key.
Press 3 “DDC Writer/Check Data”: The Kit will start to program new data of EDID into monitor, all
DDC data will display on the screen after programming.
Please refer to Fig-DDC3 below, the DDC process is finished.
Fig-DDC3
Display updated serial
number.
25
D o Not Copy V P730/bViewSonic Corporation Confidential
To Next Page
Loading...
