ViewSonic N1630w17
ENGLISH
Contact ViewSonic service team at: http://www.ViewSonic.com or call our service team: United States 1-800-688-6688, Canada 1-866-463-4775
Getting Started
Using the F Connector
The F connector is supplied for an artistic reason: to hide the Cable or VHF/
UHF antenna from being seen from the front. Connect one end of the F
connector to the TV input jack, and connect the other end with the Cable or
VHF/UHF antenna.
Cable System or VHF/UHF Antenna System
Enjoy the high-definition and standard-definition digital programming along with standard-
definition analog programming.
☼
• This TV is capable of receiving unscrambled digital programming for both cable and
external VHF/UHF antenna.
• We strongly recommend that you connect the antenna/cable input using a 75-ohm coaxial
cable (not supplied) to ensure the best picture quality.
Cable or VHF/UHF
Cable System and VHF/UHF Antenna System
Use an optional A-B RF switch (not supplied) to switch between the cable and antenna
programming, as shown below.
☼
• Remember to set the TV Source setting in the CHANNEL menu to Air or Cable for the
type you choose.
Connecting the LCD TV
75-ohm coaxial cable Rear of TV
VHF/UHF/CABLE input
Cable
Antenna
Rear of TV
VHF/UHF/CABLE input
A-B RF switch
To Next Page
Loading...
