4141
/ŶƉƵƚ^ĞƫŶŐƐ
To select an Input Source:
1.
Press INPUT on the remote control, press the setting button on the front
panel, or press the setting icon from the toolbar to display the Input
Settings menu.
2. Press T/S/W/X to select the input source you want.
EKdഩ PC source will only display when the slot-in computer is connected.
3. Press ENTER on the remote control, or touch the input source.
4. Press EPG/BACK on the remote control, or touch a blank area outside of the
menu to exit.
EKdഩ dŽĂĚũƵƐƚƚŚĞƐĞƫŶŐƐŽĨĂŶŝŶƉƵƚƐŽƵƌĐĞtouch the setting icon next to
the highlighted input source.
To Next Page
Loading...
