ViewSonic VS18886 - Page 46

46
7. Aer installing the System Control Box of both displays, the installaon wall
should look like:
Display 1 Display 2
8. Connect one end of an HDMI cable to the HDMI OUT port of Display 2. Then,
connect the other end of the cable to the HDMI IN port of Display 1.
HDMI IN HDMI OUT
NOTE: Route the HDMI cable as shown below:
9. Install the System Control Box Covers with the KM3x6mm screws from le to right
(i.e., Display 1 le cover, Display 1 middle cover, Display 1 right cover, Display 2
le cover, etc.).
NOTE: Refer to page 26 for more informaon.