6. Remote Control Unit (RCU)
An IR remote control unit shall accompany this product along with battery. In addition, this remote
control unit shall have an operational distance of 5 meters and an operational angle of 15 degrees for
both horizontal and vertical. Besides the key-code and protocol has fully conformed to VS standard.
Parameter Specification
Type IR; Made by Sighter Electronics Co., Ltd.
Range
Off axis ± 15° ≥ 5M
On axis: ≥ 7M
Life Testing
(Buttons)
100,000 cycle operations at a rate of 20~30 cycle / minute without load (with
battery)
Color
Painting Color - PANTONE 427C (Black for front & back cover)
Power Key - PANTONE 032C (RED)
Key Pads – PANTONE 10C & PANTONE 7C(Cool Gray)
Texts Printed on Front Cover and Key Pads - PANTONE 427C
Protocol VS key-code & protocol.
7. Mechanical
The following table defines the mechanical specifications of this product for both chassis and
cabinet.
Parameter Specification
Dimension
W/O stand
W=566.7mm, H=441.9mm and D=211.0mm
W=566.7mm, H=386.7mm and D=85mm
Net Weight 7.0kg
Chassis Plastic Material ABS (ABS HB )
External Plastic Chassis
Components
Plastic Chassis, Cover, Stand, Len and Button
Internal Plastic Cabinet
Components
N/A
Exterior Chassis Color Refer to- Product ID Guide
Chassis Component’s Color
Difference
Refer to- Product ID Guide
Chassis Color Drift Due to
UV-Light
The color drift due to UL-Light shall be less than 10 “Delta E”
in the 1976 CIE L*a*b color space. Testing shall be
performed according to the requirements of ASTM Test Method
D4459-93.
Chassis Texture Front Bezel:(N/A ;) Back Cover:N/A ; MT11010)
Molded Plastic Workmanship shall be inspected according to ViewSonic
Molded Plastic Parts Specification, VSCMPPSPEC001V1.2.
Screen Printed Parts, Bird
Logo Recess
Artwork shall be provided and confirmed by ViewSonic.
Rear Label A label identifying the product name, model/serial number and
FCC ID/Logo shall be placed into the rear label recess located
on the rear panel of the chassis.
Wall- Mount 100mmx100mm VESA high hole (n=4), M4 x 10mm, pitch
=0.7mm screw mounting kit not included.
Sample Sample of textured color chips, plastic material specification,
and Material Safety Data Sheets shall be submitted to
ViewSonic prior to Mass Production Release.
In addition, all exterior surfaces shall have uniform texture/color. The maximum acceptable
gap between the buckets to bezel plastic pieces shall be within 1.0mm. The maximum
acceptable gap between LCD panel and bezel shall be within 1.3 mm.
ViewSonic Corporation Confidential - Do Not Copy VTMS2431
To Next Page
Loading...
