ViewSonic X1-4K - Bluetooth Remote Control Settings

30
Bluetooth Remote Control Settings
1. Pair the remote control with the projector following the illustraons from the
setup wizard if the projector is acvated for the rst me.
• Press and hold
and together until the indicator on the remote control blinks
blue.
• A popup message will appear when the pairing is successful.
2. Or you can pair it in the Bluetooth Out page.
• Press and hold
and together until the indicator on the remote control blinks
blue.
• Select the device named "VIEWSONIC".
NOTE: The supplied remote control for ViewSonic X1-4K/X2-4K supports both
bluetooth and infrared mode. The remote control and projector are in infrared
mode when the indicator on the remote control lights up red. If the remote
control is paired with the projector in bluetooth connecon, the buons and
indicator on the remote control light up blue.