Vigia NM 343 - System Settings and Calibration; Tire Calibration and Pressure Variances

9
USER'S MANUAL
ENGLISH
Alarm
If you want to deactivate the alarm press
nevertheless if the air pressure
continúes, it will activate automatically
after 20 minutes, being able to deactivate
it again by pressing
.
40
3
BAR
160
11
BAR
60
80
100
120
140
BAR
PSI
4
5
6
7
8
9
10
PSI
PSI
Luminous intensity of the Display
If you want to modify the luminous intensity of the display press
which will increase the intensity until it reaches the maximum and
then it will decrease to the minimum so it will increase again and so
forth.
As son as it shows the luminous intensity you want release
.
Tire Pressure Variances and the Electronic Tire
Calibration System VIGIA
A- Calibrate cool tires.
The tires should be calibrated when they
are cold at ambient temperature according
to the “ination table” supplied by the tire
manufacturer.
AMBIENT
TEMPERATURE
B- Never bleed tires due to the pressure increase generated by operation
(rolling.).
Tires normally increase about 18% its initial pressure. This percentage
may vary according to the type of tires, this is why you should request
the load table to the manufacturer and appropriate pressures.
C- Over-ination generated by operation (rolling).
VIGIA has the ability to indicate over-ination when certain conditions
are met: