Vigia NM 343 - Tire Change Procedure; Rotor and Tire Removal; VIGIA Valve Installation

16
Tire Changes
A- Remove the rotor cover. Disconnect the hose/s at the rotor.
Remove the support bracket if necessary.
B- Remove the tire, being careful as to not damaging the rotor.
C- Remove the connector to the VIGIA ination valve and reinstall
the connector in the tire, keep in mind the following steps:
- Clean, preferably with a brush, the thread
of the original valve.
- Remove the inner valve.
- Adjust the VIGIA valve, tightening smoothly with a wrench. Verify that
the VIGIA valve do not graze the ring, axle, bell housing or brakes, etc.;
if necessary, modify the position.
D- Verify that the tire pressure be lower
to that of calibration value. The
equipment will be the responsible for
calibrating it to the pre-set value.
E- Replace the tire.
F- Replace the rotor support bracket.
G- Connect the rotor and the ination valves hoses with the nuts
provided.
H- Replace the rotor cover and tighten the nut.