12
Moving Unit
Remove shipping brackets from skid by removing four
bolts (two on each side) with a 1/2” (1.3 cm) deep-well
socket wench and a pair of pliers. Note: Tilting unit is not
required to remove shipping brackets.
A
Slip appliance dolly between unit and skid.
Remove unit from skid. Note: Use excess packaging
to protect decorative trim; also, verify that
leveling legs are up (0” adjustment).
Door / Drawer Panel Adjustments
On the side of each panel, at the top and bottom there is a vertical slot with a cam spacer for front to back
adjustments. In the center, there is a horizontal adjustment for up and down. All hardware needs to be
loosened before adjusting.
F
Vertical slot for front to back
adjustment
Vertical slot for front to
back adjustment
Horizontal slot for up and
down adjustment
To Next Page
Loading...
